Decepticon Terminal Radar Dish Addon 3D print model

Since having done up the Radar Scanner piece (https://www.patreon.com/posts/35475404) some time back, it felt a tad odd that it did not have a matching Radar Dish to do the scanning with.

This should fix it!

Presenting the Radar Dish Addon which features a Radar Dish which can rotate to point directly forward or all the way upwards. It sits on a stand which has couple of 5mm ports One of the uses of this would be to connect to a Scanner_Plug piece using a segment of 5mm rubber tubing. This plug then fits either side of the earlier Decepticon Radar Scanner.

If you would like the Radar Dish to stand taller, there is also the option to scale the Radar_Stem piece vertically before 3d printing so that it can be as tall as you like it!

In terms of assembly, a two 5mm rods will be needed to (1) connect through the parts of the dish assembly, and (2) to connect the pivot piece to the top part of the stand.

Well then, hope y'all have fun with this little add on to your Decepticon displays then. =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios