CyberBase System Platform Turret and Helipad for Transformers 3D print model

Here are a few more pieces to add on to the CyberBase System - a raised platform which can be used for a gun turret or a helipad!

An overview of all the parts for this addon set can be referred to in the attached render.

The top two parts form the Helipad option, followed by the four parts which make up the gun turret. Finally, the raised platform comes as a single piece.

For the helipad mode, there is a peg piece which needs to be glued to the underside of the helipad piece, before it slots into the central hole of the platform

The platform sits atop four CyberTrack Pillars and can have the WFC connectors tabbed into the slots on the sides, so it can connect to other WFC or CyberTrack pieces). Links to the previous sets will be provided below for reference.

There's a plentiful number of 5mm pegs for weapons and accessories to be added.

For the gun turret configuration, the seat attaches to the inside of the turret body, with its peg sticking out from underneath. This lets it peg onto the platform. The barrel is sized to fit nicely into the front slot, or optionally, a 5mm rod can be used to affix it in place.

The seat inside is sized to allow a prime master or titan master to sit inside the turret to control it!

Next, when mounted on the platform, you can choose to have the turret remain open, or be closed up with the provided lid too. There is another prime master port on the rear to they can be used to supercharge this mega weapon.

There are two 5mm ports on either side of the turret body, and the tip of the barrel is also fits WFC weapon effects so there will be hopefully enough customization options for your displays.

But there's more too - because the platform's central peg hole has been standardized with earlier sets, this will allow for added options of using the Flight Stand or Omni Arm with this too.

More addons for the CyberBase System are in the works too, so stay tuned! =)

As mentioned, here's a handy list of links to the earlier sets which were shown above too:

Straight Tracks & Pillars (+ WFC Connector)- https://www.patreon.com/posts/35049605 Flight Stand - https://www.patreon.com/posts/38501501 Omni Arm Addon - https://www.patreon.com/posts/33224071

Note: The full list of model releases can be referred to here - https://funbiestudios.com/model-catalog

Hope everyone has fun 3d printing a bunch of these and adding on to your displays and collections! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios