Cannon Turret for Transformers Ironfist 3D print model

Was a tad strange to have weapons specialist Ironfist from before (https://www.patreon.com/posts/58682717) without his signature heavy arms so here's launching his iconic Cannon Turret to complete his look!

This piece can be used by Ironfist in mainly two ways - the turret mode with the extended stand to prop it up, or roof-mounted for him in his alt mode.

The front of the turret has been sized to fit effect parts, and actually both sides of the cannon body feature 5mm ports so you could even have twin effect parts installed! Or even have two barrels if you prefer a more symmetrical look.

The rear of the piece features a singular monitor screen this time which allows Ironfist to do target acquisition, locking and blasting-to-smithereens-ing!

Switching over to the mounted mode for alt mode - the stand can simply be folded upwards and then pegged onto the 5mm port on his roof:

Not sure if oversized, but it does give off the let's totally overdo it with our firepower look!

Again, fit on effect parts as you like to give Ironfit a more dynamic look on display!

=== ASSEMBLY ===

Here's a handy guide outlining the parts in this kit and how they all go together:

• The Body part can either be printed as a complete piece, or as two front and back halves which are to be connected with pegs and glued together.
• The 3d printable 5mm peg has been provided, and this is used for joining the halves of the body (if you chose that option), attaching the barrel to the body, and also for the attaching the drum mag onto the top of the body. Would advise for the drum mag to only be glued to the peg and not totally with the body piece, so that you can still rotate it for some interactivity.
• The smaller connector holes for the stand parts are to be connected using snippets of 1.75mm filament.

===

Have fun 3d printing this one for your own Ironfist to get him more equipped to wreck and rule! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog