Booster Addons for Transformers WFC Siege Jetfire 3D print model

Though Siege Jetfire already cuts an imposing figure as a mighty commander class figure, it always felt that something could be done to boost (heh heh) his alt mode.

Hence, as something of an homage to his early G1 appearance, here's a boosters addon kit for that big guy! This set consists of a pair of top boosters and a pair of side skirts.

The 5mm pegs required to attach the side skirts to Jetfire are provided separately so that they can be 3d printed with higher settings to prevent them from snapping in the ports. Alternatively, a more robust approach may be to use acrylic or other solid 5mm rods instead.

This addon set also features a ton of 5mm compatible port holes for effect parts, so you're more likely to run out of effect parts then ports to shove them into!

On their own, the parts of this set can also be pegged together to create an autonomous drone configuration which can be deployed from Autobot HQ to assist Jetfire in the most dire of times

And there's a bit of a surprise in his top boosters too! They can open up and hold the Arm Blade (https://www.patreon.com/posts/39103758) done previously or any other weapon with a 5mm peg on the end. The bottom bit of the Arm Blade can be pegged on top of the booster or anywhere else too.

Also, as some would also like to see these boosters attached to Generations Jetfire, a pegged backpack piece GenJetfire_BoosterBackPack.stl is also provided to do that.

Hope y'all will have fun adding this set to your own Jetfire too! Happy 3d printing till all are one! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios