Autobot Hovercraft from Netflix WFC Siege 3D print model

Getting back to base after their little excursion to Soundblaster's mercenary camp, the Autobot scavenging team zoomed back in style in one of these hovercrafts which seem to be been requisitioned from the mercenary forces.

A couple of 5mm pegs line the top hood of the hovercraft to allow for weapons to be pegged in there to give the Autobot team greater firepower on their perilous mission. A mercenary faction logo adorns the exterior face of both rear engines.

Slots on both side of the craft allow for weapons and accessories to be placed in there, or for storing Autobot tablets if you have those 3d printed out too! There's a control panel designed in to the dashboard too, so your bots can control the hovercraft! On the rear engine, siege effects can be pegged into any of the three 5mm ports to make for an afterburn boost effect:

To be able to fit around 3-4 bots to shuttle them around, this piece had to be fairly large sized and will quite a bit of filament and time to get 3d printed out. Here's a handy assembly diagram to show how things fit together, with sections of people numbered in sets 01 - 05 from the front to the rear. Optionally, 5mm pegs can be used to hold the pieces together, and using superglue will give a more permanent assembly.

As always, have fun 3d printing this one out for your bots! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios