CyberBase System Lift Platform 3D print model

Here's another addon to the CyberBase System which was designed to allow for more two-tiered display for your Transformers!

This piece takes design inspiration from one of the earliest scenes in the original G1 cartoons while the bots were still on Cybertron.

Part of the thinking for this piece was to allow for bots of different sizes to be displayed nicely as the platform could be adjusted to any desired height. The platform has also been sized to be a rather tight fit, and so should be able to take larger, weightier figures without too much difficulty.

On a side note, it is easier to assemble and position the platform to the desired height on the wall, before adding in the side pillars and then finally pegging them onto the base piece. The latter two parts can be found in the CyberBase System Core Set (https://www.patreon.com/posts/33140482)

Also, depending on the tolerances for your 3d printer, you may have to resize the platform little to get the fit you like. Though hopefully the default tolerance provided should do the trick.

Well, hope everyone has fun with this addon to the CyberBase System then! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios