SHARK SWORD - POWER RANGERS SAMURAI - COSPLAY AND FIGURE 3D print model

• All files are in STL format.

• Model printed in parts.

CUT TYPE 1 - STL file with the blade part, body part (with 4 legs), the handle, the Power Disk and pins.

CUT TYPE 2 - Blade splited into 2 parts, body part (with 4 legs), the handle, the Power Disk splited into 2 parts and pins.

CUT TYPE 3 - Blade splited into 4 parts, body splited into 2 parts (with 4 legs), the handle, the Power Disk splited into 2 parts and pins.

UNCUT TYPE 1 - STL full uncut with paws.

UNCUT TYPE 2 - STL full uncut without paws.

Size: 860mm (86cm)

The STL files are able to be printed as a cosplay item, display item, miniature item.

This model is a dummy replica item.

• For stable 3D printing, I recommend using the Bambu Studio software.

This 3D model of the Shark Sword was made for fans of the Power Rangers Samurai/Samurai Sentai Shinkenger and also for everyone who likes swords in general.

ATTENTION: All parts were cut thinking of the size of the printing bed of the 3D printers and not for each color that the part has. So the part of coloring the pieces before/ after being printed is up to the customer’s preference! If you want to hire me for any customization, please contact me through direct messages and not by the ad itself! But if there are any questions about the STL files, these can be made in the comments section, as it may be useful to other people.

For FDM of DLP/SLA tecnology

FDM Config.:

Layer height 0.1

Perimeter Shell 3

Fill 10/15%

Supports are needed

Speed 60-70%