Transformers Armada Minicon Stasis Panel Free 3D print model

As the main conceit of the Armada series, the power-giving minicons were the much sought after partners for both Autobots and Decepticons. And here's the stasis panels they hibernated in during their journey before coming to Earth!

And like we see in the animation itself, these relatively minute panels were hidden and had to be found all over Earth - not mean feat!

But once the panels are found, the minicons would be released from their panels turning into partners who will bond and greatly power up their newly found partners!

For this take on the minicon stasis panel, they are designed to be able to be held by bots with open hands (as shown above) or pegged onto bots' hands using the version with a 5mm peg on the back.

As always, the 5mm peg will allow the minicon stasis panel to be attached anywhere there is a 5mm port on the bot too.

Due to the small size of this piece, while it is definitely possible to print on high resolution on FDM printers as we have done, getting these resin printed would probably give a crisper look! Painting it can be quite the fun challenge too!

===

Well then, we hope this will be a fun little addon piece for either your retro Armada or new Legacy Armada Universe bots. Happy 3d printing! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog