CyberBase System Pillar Extenders Free 3D print model

Here's a quick addon set to the CyberBase System which add some height to the pillars to allow the taller bots to fit better!

The need for this arose when needing to re-organize the Prime display and put Optimus here in the lower level of the CyberBase shelf. Problem is, he's a rather tall bot!

So, got to work doing up some short extender pieces which will add the needed height to the pillars. These peg into the bottom peg of the original pillars like so.

And now, the added 5cm here allows Prime to fit right under nicely.

As an alternative in the case that you don't want to use a Cyberbase Tile underneath, a variant set with flat feet have been done up also.

=== Assembly ===

The attached diagram shows a visual look at the pieces included in this set.

On top of the 5cm extender seen above, two slightly longer 10cm and 15cm versions are also included.

When pegged together, the fit should be snug enough to hold well. Alternatively, a spot of super glue can also be used to make the connection stronger and more permanent.

===

Well then, hope this would be a useful addon for your CyberBase System shelves, especially if you have large bots on display. Happy 3d printing and collecting! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog