Accessory Ports for Transformers SS86 Optimus Prime Trailer Free 3D print model

Having done the earlier Megatron Arm (https://www.patreon.com/posts/megatron-arm-for-115992754) for SS86 Optimus Prime, there might be cases where you would prefer to store either of the arms in the trailer neatly.

Here's just the set for that! This kit comprises of a pair of slide-in parts which add either a trio of 5mm ports or a specifically sized mushroom peg notch for the either a Prime or Megatron arm to be slotted in.

Here's how they look like on the reverse - mainly the tab which is to be slid into place.

First up - here's the one which goes into the left side of the trailer. This needs to be slid all the way in, aligning the base flush with the wall of the trailer.

The same is to be done for the piece which goes on the right side of the trailer. Again, flush this all the way down, importantly keep the hollow in the piece there as that's how they trailer halves need to peg together to close.

Closing of the trailer happens just just before and it should leave just enough space for roller or small bot to fit underneath in there.

And when you want to swap up the arms to go on the offensive - just safely store the other arm in the mushroom notch so it wouldn't go missing!

Of course, you could also opt to have both sides add on the three 5mm ports for accessory storage - so mix and match these up as you like! =D

So here we go - a couple more expansion accessory ports for your SS86 Optimus Prime Trailer. Have fun 3d printing this one, everyone! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog