HAMMER TIME LIGHTWEIGHT TWHACKER 3D print model

A modular hammer with interchangeable head faces.This 3 part setup. uses a 10mm Carbon fiber tube as the structure and provides the rigidity required.

x4 M3 heat insertsx4 M3x6mm Hex screws

This was designed with hammer head that can be threaded to take any 1/4" (M6) mm table or chair foot as a hammer face. these faces are available in Steel, Rubber, ABS.

This hammer is to be used as an attitude adjuster when doing sensitive assemblies. Not to be used to drive nails.

3D PRINTING SETTINGS0.2mm works, but best fitment and details, print at 0.16mmPLA or PC+ seems to work fine.