A protective cover for earbud case with side loop for key rings, allowing you to hang this case on a carabiner, add it to your home/car key rings, etc. Compatible with Raycon Everyday Earbud cases.

Recommendations for 3D Print (based on Bambu Lab specs):

• Filament - PLA (example photo shown uses Blue/Green/Metal PLA Basic)
• Scale - Maintain its original scale and dimensions (Top Half: 80.77mm x 34.05mm x 25.02mm; Bottom Half: 80.88mm x 34.05mm x 28.02mm)
• Layer Height - 0.1mm
• Default Line Width - 0.30mm
• Seam Position - Nearest
• Ironing Type - Top Surfaces
• Sparse Infill Density - 15%
• Slow down for Overhangs - Yes
• Enable Support - Yes
• Support Type - Tree Strong
• Threshold Angle for Support - 30 deg.
• Remove Small Overhangs - Yes