Printer minimum build volume required - 195*225*98mm

All inner fenders need to be removed before installing. Aftermarket front shock towers are required if you are using the matching cab. Please also use the printed rear shock towers in the included files. It is also recommended to mount the battery at the front of the chassis rails under the bonnet for direct and easy access.

The M939 Cab is SOLD SEPARATELY.

Matching sideboard flatbed for the M939 Cab specifically for the TRX6 (G63 version). The dimensions for the bed within the sideboard area are 348*194*48mm.

Similar to the cab, it is best matched with a tyre to tyre width of 240mm for best technical crawling capability. The width of the fender is 222mm wide. The wheelbase only fits the TRX6 (G63 version), which is 324mm from front to middle axle, 454mm from front to rear axle.

Body mounts are included specifically for the TRX6 chassis. Other 6x6 chassis such as SCX10 ii 6x6, and TRX6 Ultimate Hauler are NOT compatible.

Features and details included:

• Battery access hatch in bed for easier battery access (Please note this is not as accessible as some of our other battery access beds. Battery relocation to front of chassis is recommended)
• Compartment with magnetic lid for spare screws
• Scale fuel tank with fuel tank holding brackets
• Rear sideboard can open for easier cargo loading (the sides do not open)
• Functional hooks to strap down cargo
• Fully functional light buckets
• Intricate details and more!

Printing tip: If layer steps appear too big on parts, orientate them so they are slightly angled in the slicer before printing.

Be sure to check out the instruction manual and gather all required hardware for assembly.

It is highly recommended to read the instruction manual before purchasing, to ensure you have all the required tools and hardware to assemble this body.

All of these files are for personal use only. DO NOT in any way redistribute, sell in physical or digital form, or use for AI purposes. Files are embedded with trademarks. Violations will be reported without exception.

Assembly instructions:View the link below to download the assembly instructionshttps://www.aheadrc.com/manual

FDM printing:PETG filament0.2 layer heights30-70% infill densitySupports are necessary