Blasters Communicator Tower Door from Transformers the Movie 3D print model

And here's the final part of the quad-logy,... erm, four-parter, which completes the full set to make up Blaster's Communicator Tower from the movie!

The earlier parts are required to complete the whole tower and can be found here:

• https://www.cgtrader.com/3d-print-models/games-toys/toys/blasters-communicator-seat-from-transformers-the-movie
• https://www.cgtrader.com/3d-print-models/games-toys/toys/blaster-communicator-tower-pod-from-transformers-the-movie
• https://www.cgtrader.com/3d-print-models/games-toys/toys/blaster-tower-mid-section-from-transformers-the-movie

===

Seeing as to how your bots will need to be able to enter and exit the tower from below, this addon set for the Tower provides a revolving door section which simply extends downwards from the others sets so far.

There is an inner track along the upper pieces which allows the door to slide along the circular path. The grooves on the front of the door provide both a design element to it, and also can be used to slide the door open and close. From using it, it feels easier to operate the door by catching onto and sliding the grooves near the top using your fingernail.

The tower is quite ... towering! And one can still add on more layers of the mid-section of the tower to further extend it to any height as desired. Even Devastator will have problems reaching the top of the tower.

RtS Perceptor is pretty small when compared to everything else here, almost makes him look legend-scale.

The play and display possibilities are pretty endless, assuming there's sufficient space to set this all up :P

=== ASSEMBLY ===

Putting this together is pretty straightforward and can be referenced from the diagram below:

===

Well then, have fun 3d printing and putting this final piece of the Blaster's Tower together then! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog