Barbot from Swerves Bar on Lost Light 3D print model

Between missions when the Lost Light's rowdy crew needs their chilling out time, this dependable little booze Roomba was always at hand in Swerve's to help dish out the (watered-down) drinks!

How all the parts go together can be seen in the attached instructions.

Given the high details in both the arms, for the more accurate version, they will probably need to be 3d printed in resin to get the fine details out. But to be complete, another set of lower detail arms have also been designed for FDM only prints.

Additional bits required would be 5mm pegs to hold the treads, base and body parts together, as well as a little snippet of filament to be the antennae for him!

The upside of the FDM arm is that it has been designed to hold 5mm pegs, which means 'li barbot will be able to serve and share drinks with the crew too!

Hope this helps further complete Swerve's Bar for y'all! Have fun 3d printing and playing with this little bot! =)

(Note : Swerve's Main bar is available here - https://www.patreon.com/posts/30673497 . Energon cubes and glasses are available here - https://www.patreon.com/posts/37148867)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios