Anti-Gravity Blaster for Transformers Earthrise Scorponok 3D print model

Since getting Scorpy couple of weeks ago, this became one of the projects which just needed to be done. Here's introducing our take on Scorponok's Anti-Gravity Blaster and its various configurations for his base mode!

Here's the traditional look of thing for this blaster - in our case, the piece is assembled from the 5 main parts of the Body, Butt, Scope, Barrel, Mag with the Grey shield pegged on the outside.

Designed the a 5mm port into the butt of the blaster so it can be attached conveniently whereever pegs allow for it too. Kind of partial to this outside of arm attachment.

In base mode, these pieces can be attached in the traditional form with the blaster on one side and the shield piece on the other.

But of course, here are some other possibilities to play with - such as removing the mag piece, and allowing the claws to hold the blaster in position facing forward. The mag, when flipped upside down, doubles up as a weapons turret platform, with a 5mm port on the bottom (now facing upwards) and a special tab which can be attached to the sides at the top of Scorponok's ramp (as shown in the images).

Here's an alternate configuration for the blaster and the mag too. The blaster is attached using the port in the butt portion, while the mag is attached using the circular recess onto the side of the claw.

And with the that is 3d printing - why stop at just having one blaster, when you can have two?

To give a more symmetrical look, the mirror imaged version of the gun shield has also been provided to allow for it to be pegged on both sides of the base .

===

Well then, there are probably a lot of other possibilities for the attachments so will leave it to y'all to mess around with and find the rest!

As always, hope everyone enjoys this addon - and have tons of fun playing with it! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog