TSUBAKI MK-III - NO MORE HEROES BEAM KATANA - COSPLAY AND FIGURE 3D print model

• All files are in STL format.

• Model printed in parts.

CUT TYPE 1 - STL file with the balde, 3 cylinders pins (that fit the blade in the hand guard), the hand guard (The STL file is named KANJI) and the handle.

CUT TYPE 2 - Blade splited into 4 parts, 3 cylinders pins (that fit the blade in the hand guard), the hand guard splited into 2 parts, the handle splited in 2 parts too (Plus the pommel) and pins to fit all parts.

CUT TYPE 3 - Blade splited into 8 parts, 3 cylinders pins (that fit the blade in the hand guard), the hand guard splited into 2 parts, the handle splited in 4 parts too (Plus the pommel) and pins to fit all parts.

UNCUT - STL blade full uncut.

Size: 1020mm (102cm)

This model is a dummy replica item.

• For stable 3D printing, I recommend using the Bambu Studio software.

This 3D model of the TSUBAKI MK-III was made for fans of the No More Heroes game and also for everyone who likes swords in general.

ATTENTION: All parts were cut thinking of the size of the printing bed of the 3D printers and not for each color that the part has. So the part of coloring the pieces before/ after being printed is up to the customer’s preference! If you want to hire me for any customization, please contact me through direct messages and not by the ad itself! But if there are any questions about the STL files, these can be made in the comments section, as it may be useful to other people.

For FDM of DLP/SLA tecnology

FDM Config.:

Layer height 0.2

Perimeter Shell 3

Fill 10/15%

Supports are needed

Speed 60-70%