Charging Handle Right Side Engagement Device 3D print model

This is a patent-pending design for a two-piece device to convert any standard charger from left-side only to ambidextrous. Recognizing that not all standard chargers have the same dimensions, on the rear side of the base is a cut-out to insert an M2 screw and a cutout between it and the cavity for the handle to insert an M2 nut to secure it, allowing you to screw in as much or as little as you need for a snug fit.

The device secures via an M5 screw and nut attaching the lever arm to the base, with the nut in the cavity on the bottom of the base and the screw going through the holes on the base and arm. To remain horizontally stable, an M2 screw and nut are used along the bridge of the base to hook onto the cavity where the charging handle latch spring is located.

For instructions on the Epoxy Fill Variant, please see the blog post on assembling your item.

Requires the following:1x M5 nut

1x M5x20mm screw

1x M2 nut

1x M2x15mm Screw

OPTIONAL

1x M2 nut

1x M2 screw (10mm length minimum recommended)

*Epoxy Fill variant requires the epoxy or filling of your choice

By purchasing this, you agree to our Terms and Conditions and File License Agreements.