PS4 and PS5 controller support. Zombie hand coming out of an old and battered PS4 to hold your controller.

2 versions to print in one piece and in 2 pieces to optimize your time.

It prints without supports.

To give it weight if you have to make the base solid I recommend pausing the print at layer #150 (if 0.2mm layer height was used), and adding wet fine sand, resume printing. This is to give the base more stability.

Speed 60mm/sLayer height 0.2 mm for 0.4 mm nozzleLine width 0.4mm for 0.4mm nozzleInfill 10% or moreDoes not use supportsIn the 2 piece version use -0.1mm horizontal expansion for simpler assembly