Do you have a tangled mess of wired earbuds lying around? This is the solution. This is a wired earbud holder.

Print Instructions

• Material: PLA or PETG
• Supports: No
• Orientation: Place the bottom flat on the build surface

Installation

All you have to do to use this earbud holder is placed the plug end of the earbuds into one of the larger slots on either the left or the right of the holder. Then wrap the earbuds around the holder until they do not go further. After that, the last step is to place the wire right below the earbuds into the smaller slots, on the top or the bottom of the holder. Depending on how you wound your earbuds, you may have to unwind them a little bit to get the earbuds secured into the smaller slots.

If you enjoy this model, please leave a like and a comment. If you have any questions, concerns, or problems, please personally contact me.