Wednesday Frog 3D print model

I also made the Wednesday Frog, with its hilariously odd face and quirky charm.

This little creature is too unique not to appreciate!

Both a solid model and a version with hole for neodymium magnet ( 8mm diameter, 3mm thick ) is available.

** Models in the thumbnails, except for Wednesday frog (yellow one), are not included.

** When joining a magnet, apply glue to the magnet and heat the hole in the model slightly before inserting it to help it slide in.

The files are scaled to my size preference, but you may need to adjust the scale to fit your needs.

License: Private Use Only / No Commercial Use / No Derivatives

IMPORTANT: Do NOT share, redistribute, or sell these files under any circumstances—whether for free or commercially!

3D PRINTING SETTINGS

This model has been specifically tested using an Ender3 Pro 3D Printer with 0.4mm nozzle and PLA filament.

The following print settings were used:

Layer Resolution: 0.12mm (high quality) / 0.2mm (standard quality)

Filament: PLA

Printer Type: FDM

Nozzle Size: 0.4mm

The model prints very well with these settings and is recommended for use with PLA filament for optimal results.

** Supports are required. Please use the print settings that work best based on your experience.