D
davisjaron 2021-10-25 23:26:18 UTCdavisjaron
If I pay the $45 requested for this file, am I able to sell prints?
Useto navigate. Pressescto quit
Star wars Rogue One - Solo Stormtrooper Helmet 3D print model
Description
Star wars Rogue One & Solo Stormtrooper Helmet
J
jason-glisson 2021-01-13 03:28:57 UTCjason-glisson
Looks like someone else was asking the same questions about 501st qualifications. Is any of this present and is there a small bump under the right eye?
A
alain-11 2021-01-13 03:47:23 UTCalain-11
I’ve never seen a little bump under any eyes personally and this is most likely a defect in production so it’s most likely not on every helmet
branrock28
Hello!
I have a request, could you share a file with all the pieces together on the helmet?
B
bigjasoni 2020-06-23 05:24:23 UTCbigjasoni
Everything about this helmet looks great, but is there a 1/4" gap between the top of the eyes and the brow trim to make it accurate?
A
alain-11 2020-06-23 12:41:49 UTCalain-11
Thanks for the comment..but it's not there on the Rogue One version.":)
B
bigjasoni 2020-08-07 18:33:32 UTCbigjasoni
Thanks for the response. I'm looking at the 501st Legion CRL which states "Brow trim should be positioned 1/4" above the eyes" (https://databank.501st.com/databank/Costuming:TK_rogue_one). Also, the picture doesn't show recessed stripes on the tears on the back of the helmet. Are these present?
A
alain-11 2020-04-13 15:37:45 UTCalain-11
Respirator is a seperate piece but not the ears otherwise it would not be a R1 accurate helmet
Similar Models
to Star wars Rogue One - Solo Stormtrooper Helmet
