SKY FAN - POWER RANGERS SAMURAI - COSPLAY AND MINIATURE 3D print model

All files are in STL format.

Model printed in parts.

CUT TYPE 1 - STL files with the fan splited into 6 parts (plus the top part with 1 variation) and pins to fit them.

CUT TYPE 2 - STL files with the fan splited into 10 parts (plus the top part with 1 variation composed of two parts) and pins to fit them.

UNCUT - STL full uncut. The Fan part with fabric as a solid piece.

UNCUT TYPE 2 - STL full uncut. The Fan part without fabric as a solid piece.

Size:Horizontal - 433mm (43,3cm)Vertical - 382mm (38,2cm) and 468mm (46,8cm) with bottom detail.

• The STL files are able to be printed as a cosplay item, display item, miniature item.

• This model is a dummy replica item.

• For stable 3D printing, I recommend using the Bambu Studio software.

This 3D model of the Sky Fan was made for fans of the Power Rangers Samurai/Samurai Sentai Shinkenger and also for everyone who likes swords, bows, spears in general.

ATTENTION: All parts were cut thinking of the size of the printing bed of the 3D printers and not for each color that the part has. So the part of coloring the pieces before/ after being printed is up to the customer’s preference! If you want to hire me for any customization, please contact me through direct messages and not by the ad itself! But if there are any questions about the STL files, these can be made in the comments section, as it may be useful to other people.

For FDM of DLP/SLA tecnology

FDM Config.:

Layer height 0.1

Perimeter Shell 3

Fill 10/15%

Supports are needed

Speed 60-70%