HYDRO BOW - POWER RANGERS SAMURAI - COSPLAY AND MINIATURE 3D print model

All files are in STL format.

Model printed in parts.

CUT TYPE 1 - STL files with the bow splited into 5 parts (with pins), plus the disc and the back part to fit on the backside.

CUT TYPE 2 - Bow splited into 11 parts (with pins), plus the disc splited into 2 parts and the back part to fit on the backside.

CUT TYPE 3 - Bow splited into 24 parts (with pins), plus the disc splited into 2 parts and the back part to fit on the backside.

UNCUT - STL full uncut.

Size:Vertical - 947mm (94cm)Horizontal - 326mm (32cm)

• The STL files are able to be printed as a cosplay item, display item, miniature item.

• This model is a dummy replica item.

• For stable 3D printing, I recommend using the Bambu Studio software.

This 3D model of the Hydro Bow was made for fans of the Power Rangers Samurai/Samurai Sentai Shinkenger and also for everyone who likes swords, bows, spears in general.

ATTENTION: All parts were cut thinking of the size of the printing bed of the 3D printers and not for each color that the part has. So the part of coloring the pieces before/ after being printed is up to the customer’s preference! If you want to hire me for any customization, please contact me through direct messages and not by the ad itself! But if there are any questions about the STL files, these can be made in the comments section, as it may be useful to other people.

For FDM of DLP/SLA tecnology

FDM Config.:

Layer height 0.1

Perimeter Shell 3

Fill 10/15%

Supports are needed

Speed 60-70%