The Car Lift has warning labels, buttons, on and off lever, and a tread plate deck.The rams can be adjusted down for the animation as the lift rises. The buttons for up and down can be pressed in the animation and the colors can be changed to light up. Each animation is added by morphing slide controls that can be imported into Daz Studio, and was created in Poser. Every thing I make is scaled to size for Daz Studio models. In the rendered image I was changing the car lift to show bolts, for bolted to the floor, and while having a rough time with Daz Studio not saving the hair and Car Lift properly, I forgot to put the rams down, for this render. I hope you can see it has Warning labels and Pinch Point labels, I don't want Daz Studio models loosing a thumb operating it. The Tool boxes and work bench will be finished soon. Everything work fine, but I want to make sure the UV Maps can show images properly, to show stickers stuck to the tool box or whatever someone would want to add. The Pallet is ready but it is a non animated Prop, that can be add separately. This car lift has all the UV maps with the warning labels, and can be revised to add age, damage, and grime with texture maps to texture the surface, or even peal the label a little. The on and off, Up and Down text is on the image map so chances can be done with the image maps. Some of the lettering helps show the direction of the map so it is not upside down or flipped backwards.
I try to keep this type of standard with everything I make, and take the time to make the maps more even, in scale, and not show on two sides the same image, unless the area has no map and is not important, like a bottom on the floor. All the models I create has more than one side when you can see it that is attached, like the outside and the inside if you can see the inside, and all models were created with Hexagon 2.5 before animated in Poser.