3D printable chassis 1:32 scale slot car chassis to sit under the Miller Meteor available elsewhere.

The chassis has been designed to accommodate a standard motor, running inline.

The guide post will accommodate a Slotting Plus guide.

Print body at 199.2mm long. Do not scale width/height.

Chassis can be printed at 0.28mm layer height. On an Ender3 Pro this takes approximately two hours.

Build surface supports are recommended for the rear of the chassis, which is elevated in comparison to the front.

Included is the chassis, a brace for the motor and rear axle. These screw in place with M2.4mm screws (untapped holes are 2mm in diameter - this is also true for the grub screw holes on the front axle).

With regards to body fitment, apply the standard methods; posts or braces as you see fit on the chassis.

0.2 layer height is fine, but 0.12 is naturally better.

Recommend supports for the tail and running boards, and a raft to ensure the flag post doesn't lift