arturodi
So simple, yet beautifully done!
Useto navigate. Pressescto quit
Hoonicorn slot car chassis 3D print model
Description
3D printable chassis 1:32 scale slot car chassis to sit under the Hoonicorn Mustang; https://www.cgtrader.com/3d-print-models/hobby-diy/automotive/mustang-hoonicorn-printable-body-car
The body should be scaled to 144.2mm long as it's sllightly oversized in its original form.
The chassis includes mounting blocks which can be glued to the Hoonicorn body.
This is a sidewinder setup chassis with a brace to hold the motor and rear axle in place. It has been designed to accommodate a Slotting Plus guide.
4x M2.6 screws are recommended; two to hold the body on and four for the motor mount.
Chassis rails are sufficiently wide enough for a standard magnet.
W
woodchuckcan woodchuckcan
Turned out great. Had a Scalextric Jaguar XKRS with a damaged chassis. Managed to modify this chassis in tinkercad and add the body posts in and fits great. Just have to shave back behind the interior as it pushes forward but otherwise fits! Will.mod the chassis again for a Scaley Supra. I found that I had a gap in the middle of the upright sections that strength along the chassis. Had both sides but a bit of an air gap between them. Not sure if that's in the file or my slicer somewhere. But either way it is holding up well.
norchie2243
Awesome model
Similar Models
to Hoonicorn slot car chassis
