All-n-One Wall 3D model

This wall has a 2x4 frame inside with Insulation, Celotex Outside board, Wood Siding, Inside DryWall, and Wall Paper. You can hide everything down to the 2x4s and cut windows out with a Opacity Map.

The 4x4 corner can be added at mid wall, for a joining wall.

The wall is 12 feet with 16 inch centers. You could hide a hole for doors and windows throught the 2x4 studs, the insulation , and pink insulation, the dry wall, the wall paper, the siding, and the Celotex insulation board.

This wall is made for Daz Studio 4 and up.

This is part of making construction materials to build anything. With a floor and ceiling this wall does everything . I added Windows and doors where I wanted them. With the Window & Door frame you can hide the lower 2x4 and use it for a door. If you want to remove it completely you would need to unparent that 2x4 to delete it.

The floor is finished, I am just checking out every detail to make everything as perfect as I can. Then upload it very soon. All of the floors has under underpinning as a cover for the R-35 Insulation. It doubles and is set to a ceiling texture and image, to help you line up the Fluorescent 2x4ft. drop down lighting. The drop down lowers the light to light up the ceiling to put out more light. My gas wall lamp is set to something around 100,000 or more just to put out light, and the light bulb has a small filament that is cranked up to 1,100,000, while the drop down light is large enough it is bright at 700. Anyway, the bottom of the floor is finished and I will be uploading that soon. I still need to make roof materials for a roof. The image I show was built with the 2x4 studs and resizing them for what I needed. I hope you like and buy each house part. I will consider doing a chimney later. I have the cabinets, and appliances, with enough to do an inside scene in a kitchen or anywhere in the house but the bathroom, and no kitchen table yet.