Dual Toroidal Solenoid - Micro Compression Lifter - Concept.

3 pieces for the craft. top thin aluminum vibrator - center/core insulated stator - bottom thin aluminum vibrator the vibrator hull parts are also capacitor plated. electrically charged and micro oscillated generating vortical waves being pulled downwards along the hull, inside and out. pushed downward.a ventilator could allow and force in air when the motion goes up, then push out all air out of the chamber by cotracting the entire pressure chamber, mechanically, fast repetitions.

1x central stator 2x vibratory hull capacitor / micro compressor.8x solenoid pairs = 16x solenoids mounted on stator.the must be esc controlled, like a drone. the [micro] compressions of the crafts outer hull create electro mechanical micro waves around in/out the crafts hull resulting in a net lift gain.

could activate only upper half solenoids for lifting from ground or landing. could introduce a helical or radial vortex motion in solenoid activation rings. create a radial sequence using phases to create a vorticial compression motion.

open up the contraption to take in atmosphere, then compress air out again. the oscillation will be small and hard to see yet, yet every compression we gain a small amount of lift. the hull might appear sort of translucent because of the micro electro wave compression and ultra fast small motions. ultra low sound output, perhaps a low electric humm.

*if we placed a long helical tesla coil into the top and bottom aluminum condenser plates, the inner magnetic field could help contract and expand the entire outer hull or shell, ultra fast contractions, acting into and shaking its inner core the fabric the vehicle is made up of.Could place an entire radial ring of super capacitors all around each solenoid, have them have plenty of fast energy available. plenty of battery space inside the craft, as long as it is balanced, solid state might be preferred.

I think perhaps The Electro Mechanical Ladybug might be a cool ship name?

*If the outer capacitor plates where to be made out of translucent aluminum, the inner top and bottom of the floor could also act as solar cells for recharging the ships power, as well as the capacitors collection photons through perovskite dip layering.

The end goal is to keep the ship fully charged, mid air, a efficient yet hoovering low energy loop, hiding amongst a cloud... recharging from the sun...

Thank you for reading, thank you for your time and support, every like helps me out.