The Batman Who Laughs bust, Because i like the comic design of this Batman, not much the story XD

This bust has Battle damage in the crown, its only the head, probably later i will make a full body statue.

It is a little bit heavy so it make take a few minutes to load on the slicer.

For some reasons i dont know in cura this model appears with the errors mark but after some test there are no holes or non manifolds and when you slice it goes nice and without errrors, so its Ok to print and slice preferably in cura.

IMPORTANT/READ THIS

If you liked the design and for more designs and images help me by following me on:

If you like this design and for see more designs and images, help me by following me on:

Instagram.com/alexcampinhos

Facebook.com/Nexus3DCampos

pinterest.com.mx/acampos_e

Instructables: Alex Campos Estrada