The PiT Slowrider is not a replica of a specific car, but rather its design is reminiscent of typical vintage cars from the early 20th century. It is a remote-controlled toy designed for romantic rides around your home and can also serve a decorative purpose. The project is created with the aim of making it as easy as possible to print each part. Almost all parts can be printed without the use of supports.To complete a fully functional model, you will need a few additional components:• RC remote control kit – you can use any with at least two channels,• A low-speed electric motor Bringsmart N20 with a 15 mm long shaft (you can purchase it, for example, on Aliexpress),• A suitable regulator,• Ball bearings 16mm/8mm – 4 pieces, • Some micro screws and M3 boltsAll parts should be printed with 100% infill. Cyanoacrylate glue should be used to join the parts. Gears should be printed with maximum quality.A detailed assembly manual is included, showing the step-by-step process with appropriate illustrations.