Can confirm it prints up well. Had great results on my Elegoo Max 5 ultra. Hollowed out the model and it has some great places to place drain holes that wont get in the way. So far I have made a 100mm 120mm and 150mm version. Was trying to get her to match the height of a Kim possible print I did a while back. The very clean outfit will make it easy to print. Great companion to Lord Zochi, kim possible sculpt. (my one suggesting the key hole on the left foot does not fit) and the heel stem is a bit round, im going to use some green stuff to fix it. Overall joining the waist and legs was a very good fit. So a bit of super glue to gap fill is all you will need.