This was a labor of love which I am sad to admit took me far too many hours to create. So please show me some love and post a make if you print this. I would LOVE to see your version hanging on your wall!

Prints easily with no infill and no supports. Printed on my Ender 3 V2 diagonally, I was able to get it up to about 216mm (8.5") in length. I recommend 10mm in height. This gives it the best balance of strength and aesthetics. ᐰny taller and it creates too much shadow inside. Just place a nail where you want it (I colored mine with black nail polish, so it disappears into the design) and try it in different holes to get it to hang at the angle you want.

Enjoy! #RenewTheOrville