3D MODEL DESCRIPTIONHello friends, today on my profile I wanted to bring something that is not the usual logo to illuminate, but something that can be useful to you, but also to your children.

I made a 250mm high missile, obviously divided into sections so you can easily print the pieces.

Check the images to understand well how the missile is divided, I divided it in this way, to facilitate both the press, but also the change of colors.

The missile can be glued, so much below it has the threaded cap, where to let out the money, if the piggy bank was full.

If you can’t find the logo, or something that goes through your mind, contact me, I will be happy to make it for you friend, and publish it on my profile.

I also want to remind you that almost all my projects are interlocking, and have a tolerance ranging from 0.35 to 0.50mm, depending on the project I go to work, I apply the right tolerance tolerance standard of all printersIf you, like many others, don’t know what tolerance your printer has, I suggest you download my tolerance test, you can find it on my profile.

As always I want to thank you for spending your time viewing my project, and if you find it interesting, I suggest you take a look at my cults profile, because you will find a lot of interesting projects, and I’m sure you’ll find something that will do for you, I also remind you to leave me a like if you appreciate my work and follow me.

Good print my friends for anything, contact me via messages.

3D PRINTING SETTINGSLayer 0.10 or 0.15Temp 205° / 50° PLA - 230° / 65° PETGInfill 10%Top and Bottom Layer 4Perimeter Layer 3Speed 50/60 mm/s