Wolverine claws for cosplayThese are about 9 inches in length so feel free to lengthen them if you like.The knuckle parts can be glued on permanently to the claws or left separate and attached to gloves

EDITS** bottom edge has been reshaped to taper to the tip for better symmetry and knuckle groove has been rounded more

For the split version, there is a registration block that will bridge the 2 parts.NOTE it will need to be scaled along with the claw in order for it to fit properly!1/8" aluminum rod used to connect the claws to the handle and bent in order to fit comfortably in the hand.

cr-10 settings I used-3 walls15% min. infillnozzle temp 205bed temp 55brim (for split version)handle print standing on end