Targus Tripod Quick Disconnect Plate 3D print model
File: Tripod Quick Disconnect Plate.stl Name: QD_Plate PLA Material: 9.53 grams ( 0.021 lbs) Infill = 50% Size: 34.56 mm (1.36) x 34.54 mm (1.36) x 10.8 mm (0.425") Resolution: 0.20mm Layers: 60 layers Rafts: Yes Supports: No Print Time: 0 hr 45 min Function: I temporarily lost my quick disconnect plate for my old Targus tripod and found out that on Ebay they wanted as much for a replacement plate as I had paid for my tripod so I 3D printed one (careful, my old Targus seems much smaller than most ofthe quick disconnect plates on Ebay). I had to cut off a #1/4-20 screw to go into the camera but it was pretty snug. If I was going to use it a lot I would add a rubber washer between the mount and the camera. Fortunately I found my original plate so this one is sitting in my bag ready to mount another DSLR or a Gopro to my tripod. It should be printed 1:1.