MTB, trekking handlebar, for fitting with general metal fixing rings those are sold with default mass produced handlebars. Depending on fixing ring type, ring inlet part may must be cut to fit. 110 mm grip length, 120 mm full length. Recommended to print with flexible material, best with resin printers, Resione F69 and F39 resin tested. At the model bottom there is a conical extension, may it help support printing, but you can also remove it from the model.Slicer will may give warning to errors in the model, I could not find the cause, it prints out well, so you can ignore it.It gives a good grip, better use with bicycle gloves.