These models allow for the printing of the indidvidual componenets needed to assemble a fullsize Ax Bass based on Marceline's from Adventure Time. Does not play music, or anything I would consider music.Check out the video: https://www.youtube.com/shorts/MSDqtPFyXXo

You can also get access to all my 3D printable props models by subscribing to my Patreon - www.patreon.com/c/kenjutsubringittolifeSome you can also buy directly from me on Etsy - www.etsy.com/shop/KenjutsuI'm also avaialble for custom work.

Instructions were copy and pasted from my patreon:Below should be the files and instructions you need to print and assemble your very own Ax Bass based on Marceline's from Adventure Time!

A bit of warning for this one, the blade part, being so large, will require a printer with a fairly large build area. The Ax is about 15 inches across. You can print it at a diagonal but it is still pretty big.

Things you will need:

1/8 inch Gray Elastic Cord String for Sewing 55ft 3mm Round Elastic Rope Cord for Hair Ties Thin Elastic Strap Stretchy Thread for Clothes-Keychain-DIY Crafts & Project Supplies(ZH192) - Amazon

30 inch piece of 1/2 cpvc flowguard gold pipe - Hardware stores

2 3/4 inch pieces of 1/8 inch plain steel metal rods x2 - Hardware stores

1 1/4 machine screws 8-32 thread x4 - Hardware stores

3/4 post screws x4 - The aluminum ones tend to tread better with the machine screws. - Hardware stores

9x3mm magnets x 4 - Round Multi-Use Refrigerator Magnets for Refrigerator Craft Project - Approximate 9x3mm - 50 Pieces - Amazon

Paints - I used rustoleum painter's touch spray paints - Gloss Colonial Red, Claret Wine, Semi-Gloss Black, and Aluminum.

Super glue

Assembly is pretty simple. The cord is probably the trickiest. You'll want to create a loop from your cord. The knot can be housed in the StringsBottom. The Ax portion will use the steel rods to keep them aligned. You can glue them together then paint. The neck pieces along with the head will be threaded using the cpvc. Glue that together and be sure to align it as best you can, paint. Paint then glue in the 4 Tuners. The magnets for the turnable knobs, be sure the magnets are going to right way so they done repel. For the Stings top and bottom, it helps to hold them in place with a screw driver or something when you're trying to get the strings and screws in place. Do not glue these in place, the screws will hold them.

Think that is about it. If you have any difficulty assembling or downloading files, do let me know and good luck!