Hey guys!I am very grateful for all your support so far! :)This my second deadpool bust model,I'm trying to figure out what you might like,

I put wrought iron on the deadpool's head, same as Deadpool 2 movie :))

I'm uploading this model for HALF THE PRICE because you always support me!

""You can Print ONE PART, just ask me and I'will send :)

""Empty inside for SAVE FILAMENT but if you want without hole, I can send it, too :)

""Very High Detailed

""Bust and Display are seperate

Use Ultimaker Cura please

I hope you like it guys! If you have any question about my designs or anything, please do not hesitate to write me a message!

See you on next projects!

3D PRINTING SETTINGSENDER 3

USE ULTIMAKER CURA FOR SLICE

25cm (With Display)

0.1mm Layer%20 infillWith Support

30 Hours Printing Time

You can print smaller :)