3D Printable Blue Beetle mask.Some diy is necessary,like glueing,sanding and fitting,and two 2mm diameter 13mm length pins is needed.Glue the eyes to the face,then glue the head top to jaw,then glue the face to the head top and jaw section.put the swivel pin in between the locating parts on head top and insert a 2mm pin,then put the head back locating section on the swivel and insert the other 2mm pin and clip closed.Sand and fit parts as necessary or required.I also recommend printing with 100% infill , 0.14 layer height steps,support and brim.