This is my rendition of Aemond Targaryen's Weapons, this is the design for the TV show House of the Dragon.

Aemond's weapons are not made of Valyrian Steel, but rather regular steel, decorated as befit Targaryen Royalty. His weapons are long and sharp.

“I'm bext in line to the throne, should they come looking for me, I intend to be found" --Aemond Targaryen.

This is a 3D model, designed for printing. Please leave a like and a rating if you enjoy it. Also, I would love to see your makes!

This file is for your personal use only, and resale is prohibited. please, do not use my models to sell 3D prints without permission.

3D printing settings

The sword has been cut into 15cm segments to maximize compatibility to most printers.

There are two versions of almost all pieces. Half in the filename, means you can print the file horizontally, and full means you can print it standing in the printing plate. The full guard piece will probably require supports.

The sword has a hole for an internal support rod (100cm x 54mm)

There are small alignment holes (of about 2.2mm diameter) in each piece where you can place small filament segments (40mm or 1,57in long) to help you align and secure the pieces.

The length of the sword is about 110 cm (43,3 Inches)

The dagger has been cut into 15cm segments to maximize compatibility to most printers.

There are two versions of almost all pieces. Half in the filename, means you can print the file horizontally, and full means you can print it standing in the printing plate. The full handle piece will probably require supports.

The dagger has three holes for internal support wires (45cm x 2mm) (I usually use a drill to twist the wire until it's rigid but you can do it manually too). I also made a joiner piece that will help you give the dagger more rigidity.

The length of the dagger is about 52.6 cm (20,71 Inches)