EZ-85 80mm brushless micro quadcopter frame with 45 degree mount for flight controller 3D print model

This is my own design of micro brushless frame.

EZ-80 80mm brushless quadcopter frame designed to fit :

2" propellers 20x20 flight controller (perfect for aio fc+esc+pdb) 11xx motors

Camera mount and antenna protector should be printed with FLEXI material.

If you printing with PLA :

Start with few layers of flexi filament, then again in a middle 2mm of flexi, and put flexi again on 90% of progress.

If you printing in ABS or other than PLA it will be fine.

Check my other frames