Channel the dark power of the Daedra with this intricately sculpted plate, featuring sharp gothic curves, layered armor plating, and an otherworldly aesthetic. Perfect for cosplay warriors, dark elves, or demonic queens, this armor piece combines elegance with menace for a striking chest armor display or wearable cosplay accessory.

Measuring InstructionsFor cosplay wearables:

Measure around your chest at the fullest point while wearing your intended base clothing.

Compare with the model’s internal measurements in your slicer software.

Scale proportionally for a snug yet comfortable fit, allowing room for padding or lining.

For action figures/dioramas:

Measure the chest width of your figure.

Scale proportionally in your slicer.

Test print a small section to confirm fit before printing the full piece.

Printing TipsMaterial: PLA or PETG for wearable strength; resin for miniature display versions.

Supports: Required for pointed armor edges and undercuts.

Layer Height: 0.1–0.15 mm for clean surface detail.

Infill: 15–20% for cosplay size, 10% for miniatures.

Assembly: Can be printed in one piece or split into halves for smaller print beds.

Finishing OptionsPainting: Deep metallics like bronze, steel, or obsidian black for a Daedric look.

Shading: Apply black washes in recessed lines to enhance depth.

Highlighting: Dry-brush silver or gold on raised edges for battle-worn contrast.

Model Type RecommendationsWearable Armor / Cosplay Plate

Miniature Armor Accessory

For cosplay fit adjustments, a hairdryer (or heat gun on low) can be used to fine-tune the curvature and fit.