helm of domination from warcraft, for 3d printing and cosplay.

i printed the helmet on my tronxy x5, but the files arent too big.i also sliced the helmet to seperate files to make printing easier as my bowden setup causes stringing and i didnt want to commit to a long print, but i added here the unsliced filesso anyone can slice them how they fit.with the corona situation i cant find the means and the time to actually sand and make it pretty, so sorry for the ugly prints in my pictures.

the model is built out of 6 distinct meshes.

• the crown- the largest piece, full of sharp corners. i sliced each horn to a seperate object to make cleanup easy, i also sliced it in the middle so i would have a flat bottom layer and less noise from support.

• the cheeks- 2 meshes, left and right( they are not identical), i printed these with supports from meshmixer( meshmixer overhangs) this allowed me a much cleaner finish.

• the neck- the neck is the same model printed 4 times, it has registration holes in it to align and connect. i suggest connecting them with a strap to make a non rigid connection.

• the crystal- the crystal should be blue\ red transperant. so i added the actual mesh that should slot in the groove on the crown, but i also added a buck mesh for heatforming-the nose- the nosepiece has a small hole in it for a screw to connect to the crown.