This pack consists of 5 distinct characters. Lumiere, Cogsworth, Mrs. Potts, Chip and Plumette from 1991's Disney's animated movie Beauty and the Beast.
LumiereThe complete dimensions for Lumiere are the following (mm):
Height- 335
Width- 240
Depth- 126
There are two versions available. In the first one, you will have holes in the candles for you to be able to use electric candles in them.In the second version, the candles have no holes in them, and the flames are included in the sculpture (to be painted, for example).
The electric candles used have the following dimensions (flames are not included in these dimensions since they should be above the hole for full effect):
Height- 28 mmDiameter- 36 mm
DISCLAIMER: Do not use real candles due to fire hazards.
CogsworthThe complete dimensions for Cogsworth are the following (mm):
Height- 240
Width- 121
Depth- 68
Mrs. PottsThe dimensions for Mrs. Potts are the following (mm):
Height- 160
Width- 186
Depth- 208
Mrs. Potts Hat
Height- 549
Width- 130
Depth- 130
Chip
The dimensions for Chip are the following (mm):
Height- 798
Width- 766
Depth- 984
PlumetteThe complete dimensions for Plumette are the following (mm):
Height- 248
Width- 158
Depth- 145
Note: The string shown in the render screenshot is not printed. To achieve this effect, you should add a real string to the appropriate hole in Plumette's head.
Sculpting software used: Blender
Render method used for the previews: Cycles
Filament: PLA
Slicer used to 3D print: Ultimaker Cura
Settings I've used to 3D print:
Standard quality - 0.2mm
Infill - 20%
Supports:
Lumiere - I've only used supports for Lumiere's nose. The rest should be safe enough to print without them.
Cogsworth - You can print this piece up or lay it down, depending on your preference. Standing up (printed by default), needs some supports on the chin, arms, and body interior.
Mrs. Potts and Chip - I've used supports for their noseand for the hanging parts of the hat.
Plumette - This might depend on your printer settings and skills. So, you can have supports for the head or no supports at all.
Speed - 50% first 20 layers and 100% for the rest
Plate Adhesion - Skirt
Cooling - Enabled
Travel - Retraction Enabled
