Maple leaf 3D print model

Print ready Maple leaf.

Measure units are millimeters, the model is about 2 cm in width.

Mesh is manifold, no holes, no inverted faces, no bad contiguous edges.

Available formats: .blend, .stl, .obj, .fbx, .dae

Here is three versions of the model:

1) Mpl_tnin. (.blend, .stl, .obj, .fbx, .dae) Thin, about 0.85 mm version. 692 triangular faces.2) Mpl_tnick (.blend, .stl, .obj, .fbx, .dae) Thick, about 1.5 mm version. 3) Mpl_FB (.blend, .stl, .obj, .fbx, .dae) Flat back version.