3D print models (STL files) of the Cthulhu Statuette, created by John Hannon. The STL files were created using the original high resolution 3d model, then adjusted for the 3dprinter. I have included 3 versions, the first two are a hollowed model, one with supports and one without in case you wish to add your own yourself. I have printed this myself with a Photon M3. I have also added a solid version in case you want it be a bit weighty to hold. I have not tested this version but will do so in the coming weeks, if there are any issues with it I will update the model, feel free to send me a message if you come across any issues.

IMPORTANT: licensed Creative Commons – Non Commercial/No Derivatives (nc/nd) You are not licensed to sell 3dprint kits made using this STL, redistribute or adjust the digital files, unless for own use!

Printing instructions: The model prints as one full model with supports, a little bigger than a coke can at the current size however scaling shouldn't be an issue.

Finishing instructions: To finish I used a gundam kit file and some nail files to shave down any areas where the supports attached. I also filled the hole on the bottom with some modelling putty and hot glued some felt to the bottom to complete the look I wanted. It shouldn't require much else.

The 3d models are made by me. The file is packed in a zip file. This can be unpacked by most operating systems without the need of additional applications into your useable STL files. If you do not unpack them, the models will not work!

License information: You may not share, change and share, sell the digital files or sell 3D prints made with it. You may use the files for personal use and single-use commissions only. Attribution must be given at least once if your project is published, and used these files: mention John Hannon in your project description. FILE HAS BEEN TEST PRINTED SUCCESFULLY