Welcome to the Armory

Our month of Sept 2021 release is the rings from Shang-Chi and the Legend of the Ten Rings STL

File comes cut and keyed in 2 pieces suitable for FDM or SLA printing

This is just for the digital file, physical print and patreon access not include in Cgtraders sale

Get early access to our Patreon @BlackGorillaArmory

Join our community and get tips and tricks on printing and finishing your models. As well get the licensing to sell your own prints of our models.

Check us out today! For personal use only for anyone not a member of our Patreon

3D printing settings

Test print was done with supports on an CR10 v2 with 0.2 mm layer heightTop of ring rounding does not need supportsThe original is for a 2.5in dia.to scale measure your forearm where you want itexample 5in and divide that by 2.5. and times that number by 100%so for that you would scale the width and the height of the ring by 200% BUT not the thickness of the ring. that would stay constant. for the light to affect you just line and join glow sticks inside the rings in the hollow section. I used just cheap ones from the dollar store. If you need smaller than 2.4 and greater than 4.9 inches you may experience issues printing or with glowing