AI-Ball figure of Tama from AINI. Includes Pleading and Normal variations.
Personal Recommended Cura Settings:
Walls:
Infill:
- Infill Density: 10%
- Infill Pattern: Lines
Support:
- Support Placement: Everywhere
- Support Overhang Angle: 60-65 degrees
- Support Density: 15-20%
- Enable Support Interface
- Enable Support Roof
- Enable Support Floor
- Use Towers
Build Plate Adhesion: Raft
Angle: It is recommended to print these files at an angle where minimum support is required, while being enough to prevent the print from failing. I tend Tama at a slight angle, with her head on the build plate (like ALMOST upside down, but not completely).
Copyright: This is PERSONAL USE only. You cannot sell the file or print and sell the figures.
