This 3D model was originally created with Sketchup 8 and then converted to all other 3D formats. Native format is .skp 3dsmax scene is 3ds Max 2016 version, rendered with Vray 3.00 November 15, 2015, 4:36PM flight 288 takes off from runway 18R of Dallas Forth/Worth International Airport. CargoLux flight 9330F approaches and notices the board on take off. The aircraft goes around and leaves a dramatic jet blast. The blast decompresses the aircraft's emergency exit and the aircraft's fuselage around the door deforms and the door is now falling apart in pieces. The blast snubbles into the aircraft's engine %2322 and it starts falling apart and explodes. While the CargoLux made a fatal go around and now approaches the aircraft. The blast affected the gear doors and the tail, now the tail falls off and the rudder de-attaches from the main tail. The gear doors fall on ground, and the whole aircraft tilts to the right. As the tail falls off the nose wheel turns, so it is too late to pull down. Now the tail of the United 777 hits the nose gear of the 747. The 747 flies away to a different runway and makes an emergency landing, while the 777 completely brakes off, lifts into the air, tilts, fuselage fully decompresses and explodes, and the whole aircraft falls to the ground. NTSB concludes that the mistake was because of CargoLux pilots - they forgot to extend flaps and thus didn't land in the required runway part. Co-pilot after the emergency landing which the 747 performed after flying away with the broken landing gear died instantly. Too hard was the emergency touch down. Explosion by Max Grueter, both aircraft by WilliamT.